Meter Savings
How Can I Save?
Set Your Domestic Hot Water to a Suitable Temperature:
Set your device's domestic hot water temperature to a suitable level (40-450C). Overly hot water will both harm your skin and require you to use cold water to adjust the temperature.
Have Your Devices Serviced Regularly:
Having the annual maintenance of combustion devices such as combi boilers done by an authorized service before winter increases device efficiency and saves fuel. Also, for your combi boiler to run efficiently, make sure the water pressure is set between “1.5-2 bar”.
Don't Turn Off Combi Boilers; Set Them to a Low Temperature Instead:
When you leave home for a short time, do not turn off your combi boiler completely. More natural gas will be needed to heat up again, and your home will take longer to warm up.
By law, room temperatures cannot be set below a minimum of 15 C. This is also not a suitable way to save. The cost of letting the home cool completely and then reheating it is much higher than the cost of keeping it warm.
In terms of fairness, this practice also causes our neighbors to consume more energy than necessary because of the heat loss caused by this unit.
Condominium Law No. 634 (Kat Mülkiyeti Kanunu), Article 18: When using their independent units, as well as annexes and common areas, owners are mutually obliged to act in good faith, in particular not to disturb one another, not to violate one another's rights, and to comply with the provisions of the management plan.
Central Heating Cost Sharing Regulation, Official Gazette No. 26847, Article 5-(6): Room temperatures in independent units heated by central systems are set to a minimum of 15 ˚C.
Use Thermostatic Valves on Radiators:
With a thermostatic radiator valve, the temperature of each room can be controlled separately. When the room temperature reaches the set value, it automatically reduces the flow of hot water and closes the valve, preventing the radiator from giving off heat unnecessarily.
Use a Room Thermostat:
The ideal comfort temperature is between 20 and 22 0C. Use a room thermostat for comfortable and economical heating. By setting the thermostat 1 degree lower, you can save up to 6% on fuel. Set rooms you don't use to position 2 and rooms you will use to position 4; if you don't like it very warm, set them to position 3 and close the door. Make sure your valve is not open above 4.5 (45 C).
Don't Cover the Front/Top of Radiators with Furniture or Curtains:
The ideal comfort temperature is between 20 and 22 0C. Use a room thermostat for comfortable and economical heating. By setting the thermostat 1 degree lower, you can save up to 6% on fuel.
Use Heat Insulation Panels:
Radiators spread the heat of the hot water circulating inside them into the room. To prevent heat loss from radiators to the outside, place heat insulation panels between the wall and the radiator.
Insulate Windows and Doors:
Use double glazing on your doors and windows to prevent heat loss. Check that the seals on doors and windows are intact and airtight.
Insulate the Building:
Saving on natural gas means heating with less fuel without compromising comfort. By insulating your building and roof to minimize heat loss, you can save up to 40%. By preventing humidity, condensation, bacteria, and mold, you can make your home healthier.
How are savings achieved in a central heating cost sharing system?
A heat cost sharing system undeniably provides savings for the building as a whole.
In buildings that chose this system, natural gas usage compared to the old system has dropped by at least 20% and at most 60%.
These figures were consistently determined by our company by comparing the monthly natural gas spending on the natural gas bills of buildings before they switched to the system with their spending after switching.
A heat cost sharing system provides savings for the building as a whole. However, if you do not take any savings measures in your own usage, the share calculated for your unit from the building's reduced main bill may be higher. In this case, we recommend reviewing your usage and saving more effectively.
On the other hand, if you live in a new site and the occupancy rate in your project is below 50%, the occupancy rate may need to rise above 70% to achieve the real savings rate.
Why a central system? Wouldn't it be better to use combi boilers?
A central heating system provides much more comfort and efficiency than a combi boiler system. If you live in a building with combi boilers, neighbors who turn their combi boilers off completely cause you to consume much more heat energy.
Under heat cost sharing regulations, however, room temperatures in a building with a central system must be set to a minimum of 15 C. You won't experience heat loss.
On the other hand, since hot water in a central system is supplied from a single boiler, higher savings are achieved across the building. The central system boiler is operated and maintained by a professional team. In this respect, it is also much safer than a combi boiler system.
Was this article helpful?