Estimated Consumption Calculation
According to the Central Heating Regulation (Merkezi Isı Yönetmeliği), if no value can be obtained from an independent unit's meter for any reason, then pursuant to Section 5, Article 11 of the regulation, the "Estimated Consumption Application" is carried out.
SECTION FIVE
Cases where heat and hot water shares cannot be determined and a cost allocation document cannot be issued
ARTICLE 11 – (1) If the heating or domestic hot water shares of independent units cannot be determined during the cost allocation document period because a piece of equipment has failed or cannot measure accurately for a similar reason, the shares are determined by the building manager, the building management board, the energy manager, district heat distribution and sales companies, or authorized metering companies, based on the consumption of those independent units in previous similar cost allocation periods or the consumption of other similar independent units in that cost allocation period.
SAMPLE CALCULATION METHOD
As an example, let's assume no reading can be obtained from the meter of unit 3, and let's do a sample estimated consumption calculation for this unit:
Net m2 of the unit to which the estimate will be applied * 0.9 = X
Net m2 of the unit to which the estimate will be applied * 1.1 = Y
The average consumption of the units whose net m2 falls within this range, including X and Y m2, becomes the estimated consumption of the unit to which the estimate is applied.
85 * 0.9 = 76.5 m2
85 * 1.1 = 93.5 m2
Since the net m2 of units 1, 2, 4, and 5 are within the calculated range (76.5 m2 – 93.5 m2), the average consumption of these units is reflected to unit A-3.
100 kWh + 500 kWh + 350 kWh + 100 kWh = 1050 kWh
1050 kWh / 4 units = 262.5 kWh (estimated consumption)
In addition, information about meters from which healthy readings could not be obtained is shared with the site management in the "Apsiyon Notification Center".
Clicking the notification redirects you to the "Meter Reading Report" page. This page contains information about the meters that could not be read.
Information about meters that could not be read is indicated in the control files sent to the management before distribution, in the "Estimated" column.
The meter to which an estimate was applied is also indicated in the expense documents generated after distribution.
Was this article helpful?